sales@autoteko.com

+86 571 85238880

TECHNICAL SUPPORT




PROFESSIONAL, MONOGRAPHS, ONLY FOR QUALITY

HOW TO REPLACE THE HUB BEARINGS
1-BRAKE SHIELD                                        6-HUB AND NEARING ASSEMBLY 
2-WASHER                                                  7-STEERING KNUCKLE
3-RETAINER                                                8-BOLT 
4-COTTER PIN                                            9-TONE WHEEL(ABS)
5-NUT

1.So, to get started, just jackup your Jeep
2.Remove the wheel and brake caliper, being sure to support the caliper (don’t let it hang from the line)

3. This is what the hub / bearing assembly looks like

4. With a pair of pliers, remove the cotter pin

5. With your hand, pull off the retainer

6. Here is what the cotter pin and retainer look like
8. Remove the washer

7. Remove the wheel nut. Air tools make it easier

9. Remove the three bolts holding the hub assembly on

10. Pull the hub assembly off with your hand

12. Install the hub assembly, and tighten the three bolts that keep it in place.

11. At this point we begin reassembly.

13. Put the washer back on

14. Replace and tighten the wheel nut

15. Replace the retainer and install a new cotter pin, and put the brake rotor back on

16. Re-install the brake caliper